Not shown | Sears 831.287602 instruction

• .•

5. Piug the P_-ei" Co_ (70)into		_eja¢l_, #t the back of the _Fe_';,		5_ . "_--
;	bike. Test the console in the foLlowing'manner:_:.:_t_._Y,i_'._,? ii: _!			!! ;_: .		_. ".-.,.,,:
:	:..-_,:_;_-.,_ _-_v_:_:_._:-!_:::.	_ -__._,:;.._o'_,_s...	_,_-;_,_'_,'_ _			_. ".-.,.,,:
:	A.Pl'_gthetransf0_r0,ithepowe_Cord_O)intoa:l20:v01_		!;_._,;	'=;::;_!_!:	:	-: ::_-- ,. :: .

B. Press the power button on the console (see the drawing at the top of page 9). The manual mode indicator will light and the LCD display will appear. Next, move the manual resistance control. You will hear the motor as the resistance changes. Next, press the progranV'manualbutton. The program mode Indicator and the eight segment indicators will light.

If the console does not function as descdbed, see assembly step

4. Make sure that the wire is plugged correctly into the wire7O harness,

6.Slide a 5/8" Spacer (57) and a 5/8" Handlebar Spacer (76) onto each side of the handlebar shaft of the Frame (t 1). The open side

of each 5/8" Spacer (57) must be turned toward the Frame.	67

Slide the Left and Right Neck Shields (67, 68) onto the handlebar shaft of the Frame (11). Insert the four 3/4" Phillips Screws (4) into the Left Neck Shield, and tighten them into the Right Neck Shield.

	7. Slide a Handlebar (9) onto the left side of the handlebar shaft of	7
	the Frame (11). Tap a 5/8" Plastic Cap (3) onto the handlebar	7

	shaft.
	Attach the other Handlebar in the same manner (not shown).

8.Insert a 5/16" x 1 3/4" Bolt (36) through the lower end of the left Handlebar (9). CAUTION: The lower end of the Handlebar may have a rough edge. Be careful to avoid cutting your fingers. Tap a Link Arm Bushing (58) into a Unk Arm (37). Slide the Unk Arm onto the Bolt. The flange of the Link Arm Bushing must be turned toward the Handlebar, and the opening in the end of the Unk Arm must be downward as shown. Tighten a 5/16" x 18 Nut

(17)onto the Bolt. Do not ovedighten the Nut; the Link Arm must pivot freely. Clip the Link Arm onto the lock rod.

Attach	the other Link Arm to the right Handlebar in the same	17
manner	(not shown).

Lock Rod

(not shown).