Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document before set up or use of this product.
Distance Measurement
1.Place measurement base against object to measure from.
2.Point at target and press READ. Laser will show only while READ is pressed.
3.For a continuous measurement, press and hold READ while moving.
4.Each measurement erases the previous one.
5.Measured distance is displayed as Current Result at top of the Display.
6.Unit automatically turns off after 30 seconds of inactivity.
7.TIPS:
•There must be no objects in the measurement path.
•For accuracy, choose a target that is flat and large with hard surfaces or put a piece of cardboard in front of the target.
•The meter will only measure up to glass, but not through it.
Addition
Note: Addition can be used for distance, area, or volume measurements.
However, those measurements are different units (for example, feet, square feet, and cubic feet) and cannot be added together.
1.Take first measurement as explained under “Distance Measurement”.
2.Press + / = button.
A + will appear above and to the left of the Current Result.
3.Take another measurement as explained under “Distance Measurement”.
4.Press + / = button again. Combined measurement is displayed as Total Result at the bottom of the display.
5.Steps 3 and 4 can be repeated to add more measurements.
Page 6 | For technical questions, please call | SKU 67802 |