Memory
Note: Memory can be used for distance, area, or volume measurements.
1.Press MEM INPUT to store displayed Total Result in memory. If only a Current Result is displayed, it will be stored instead. MEM will appear on Display.
2.Press MEM RECALL later to display stored memory and clear it. MEM will disappear from Display.
3.MEM RECALL can be used in steps 1 or 3 of “Addition” instead of taking new measurements.
Area/Volume
Calculation
Note: Area/volume calculation cannot be exited before calculation is complete.
1.Press 
button to enter area calculation mode or
press 
button to enter volume calculation mode.
2.The L will blink.
Take measurement for length as explained under “Distance Measurement”.
3.Then, the W will blink. Take measurement for width as explained under “Distance Measurement”.
4.For area calculation, the H will blink. Take measurement for height as explained under “Distance Measurement”.
5.The area/volume is displayed as Total Result at the bottom of the display.
6.The Current Result will display the last measurement taken. Press READ briefly to cycle through the measurements taken.
7. Press 
or 
button to take another area or volume calculation.
8.Press and hold READ button for a few seconds to exit area/volume calculation.
SKU 67802 | For technical questions, please call | Page 7 |