ASSEMBLY STEP
STEP 01
•Attach the FRONT STABILIZER (3) to the MAIN FRAME (1) with the SCREWS (12), arc WASHERS (15) and CAP NUTS (14 ).
•Then attach the REAR STABILIZER (4) to the MAIN
FRAME (1) with CARRIAGE BOLT (12) , ARC WASHERS (15) and CAP NUTS (14).
STEP 02
•Connect the SENSOR WIRE (50) in the MAIN FRAME (1) with the EXTENSION WIRE (51) on the UPRIGHT TUBE (2).
•Get the TENSION CABLE (59) out of the MAIN FRAME (1), and con-
nect it with wire on the TENSION CONTROLLER (58) as step belowe:
Step 2.1: Put the CABLE END (58) into the SPRING HOOK (59).(pic A)
Step 2.2: Pull the knob and force the SHORT CABLE (58) into the GAP
OF THE BRACKET (59). (pic B)
•Tension is increased by turning the knob clockwise.
•Insert the UPRIGHT TUBE (2) into the MAIN FRAME and fix it with SCREWS ( 11) and are WASHERS (15)
STEP 03
•Take off the NUT CAPS (68), NYLON NUTS (22) and WASHERS (43). Attach the SLEEVES (6) to the UP RIGHT TUBE (2) with the WASH- ERS (43) and NYLON NUTS(22).
•Take off the NYLOCK NUTS (76), and attach the other one end of the PEDAL TUBES (7) onto the CRANK (21)with the NYLOCK NUTS (76) and screw driver.