SET UP INSTRUCTIONS
Place the Magnetic Recumbent 4825 Bike in the area where it will be used. It is recommended that the Magnetic Recumbent 4825 Bike be placed on an equipment mat. The Magnetic Recumbent 4825 Bike is approximately 58 inches long (max.) x 26 3/4 inches wide x 31 3/4 inches tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 7 feet long is required for safe operation of the Magnetic Recumbent 4825 Bike. Make sure that adequate space is available for access to and passage around the
Magnetic Recumbent 4825 Bike.
LEVELING: Adjust the LEVELING CAPS(50) on the REAR STABILIZER(4) so that the Recumbent Bike sits on the floor without rocking.
MOVING: The Magnetic Recumbent 4825 Bike has a pair of WHEELS(49) on the FRONT STABILIZER
(2). Lift up from REAR STABILIZER(4) to move the Magnetic Recumbent 4825 Bike.
EQUIPMENT MAT
Please note the Rear Frame of the Recumbent Bike is adjustable. Use the longest size to determine the size of the mat.
FUNCTION INSPECTION:
Visually inspect the Magnetic Recumbent 4825 Bike to verify that assembly is as shown in the above illustration. Check the function of the Magnetic Recumbent 4825 Bike by turning the crank slowly through one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(25) and verify that it functions properly.
CAUTION: Locate and read the WARNING LABEL(78) on the Magnetic Recumbent 4825 Bike. Make sure that all users read the WARNING LABEL(78).
10