True Fitness 750EA, 600EA manual No Resistance

Symptom	Probable Cause	Corrective Action	Recommended Tools
NO RESISTANCE	Console Set
750E, 750EA	•	Remove console bolts to access 7-pin
		connector. Do not disconnect console	Note:
		set.
	• Enter DA (resistance) test mode.
		(Page 3).	You must pedal at least
	• Press + key to force .7 VDC out of		30 RPM when
		panel.	performing any voltage
	•	Set meter for DC Volts. Measure	test. You may require the
			assistance of another
		between #2 pin and #4 pin at 7- pin	person when performing
		connector.	voltage checks.
	• Is .7 VDC present? No- replace console
		set. If present, continue on.	Multi-meter
	Defective Cables	--------
	• Remove right mast cover and handlebar.
	• Measure between the #2and #4 wires at
		the 7 –pin connector on the lower board.
	• Is .7 VDC present? No- replace cable
		for console. If present, continue on.
	Power Resistance	--------
	•
		DO NOT PEDAL.
	• Set meter for resistance. Disconnect 3-
		pin connector at the lower control board.
		Measure resistance between #1 pin and
		#3 pin.
	• Resistance should be 10 ohms, +/- 1
		ohm.
	• If less than 10 Ohms- replace power
		resistance. If resistance checks OK,
		continue on.

--------

•DO NOT PEDAL.

•Remove main body cover, set meter for continuity.

•Disconnect brake cable from brake and lower board.

•Check continuity of all wires in cable.

•Check for cross continuity- this would indicate multiple shorts in the cable.

•No continuity? Replace Brake cable.

•Yes continuity? Replace lower board.

Page 4

Support Services 800-883-8783 Mon-Fri 8:30am-5:00pm Central Time Zone Fax: 636-272-7148