Vision Fitness X6000DA manual E P 5 B L a C K B a G, East Lake Street P.O. Box 280 Lake Mills. WI

S T E P 5 B L A C K B A G

• Slide a large wavy washer (M26) onto the console mast axle. Locate and slide the right upper handlebar bracket onto the console mast axle and attach with a washer (M8 x 35) and M8 NyLock nut, using the 13MM wrench. Snap the plastic 13MM nut caps over the nuts.

S T E P 5	• Slide a small wavy washer (M16)
	onto the lower pedal arm support,
	followed by the right lower arm.
	Attach with a washer (M8 x 25) and
	bolt (M8 x 12MM), using the Blue 5MM
	Allen wrench.

• Pivot the lower arm and insert the top end into the upper handlebar bracket. Attach with bolts (M7 x 35MM) and (M6 x 12MM) through the side, and bolts (M8 x 12MM) from the front. Tighten using the Blue 5MM Allen wrench.

• Repeat the above steps to attach the left-hand upper and lower arms.

621-D East Lake Street • P.O. Box 280 • Lake Mills. WI 53551

toll free 1.800.335.4348 • phone 1.920.648.4090 • fax 1.920.648.3373 www.visionfitness.com

2001 Vision Fitness. All Rights Reserved. 4.01 Part #Z60EP08-AG1801PRD

AG18.01PRD	U.S. Patent No. 6,190,289
REV3

8