assembly. The rod end bearing should be positioned to the inside of the bracket on the Lower Handle Bars. Install two 5/16" x 32m/m Hex Head Bolts (71) through the left and right Lower Handle Bar brackets and the rod end. Install two 5/16" x 20 x 1.5T Flat Washers (98) and two 5/16" x 7T Nylon Nuts (105) on the 5/16" x 32m/m Hex Head Bolts (71) and tighten firmly by using 12m/mWrench (110) and 13/14 m/m Wrench (111).
2.Install the two Rear Rail Tubes (16) with rear end of the Main Frame (1) and secure with two 3/8 x
3.Install the Rail Stabilizer (15) between the rear end of the Rail Tubes (16) and secure with four 3/8 x
STEP 4: Beauty covers assembly
1.Install the Connecting Arm Covers (59 & 60) over the connection of the rod end and Lower Handle Bars (4 & 5) with four M5 x 15m/m Phillips Head Screws (79) and two 3.5x12m/m Self Tapping Screws (84) by using the Phillips Head Screw Driver (108).
2.Install the two Wheel Covers (52) on the pedal arms above the Wheels with the four M5x15m/m Phillips Head Screws (79).
3.Install the Front Handle Bar Covers (54 & 56) and Rear Handle Bar Covers (55 & 57) over the Handle Bars axle connections with the six 3.5x12m/m Self Tapping Screws (84).
4.Install the two Middle Stabilizer Covers (61) on the joint of the Rail Tubes (16) and the Stabilizer. Secure the covers with two M5 x 15mm Phillips Head Screws (79).
5.Install the Rear Stabilizer Covers (62 & 63) on the rear end of the Rail Tubes (16) and secure them with two M5 x 15mm Phillips Head Screws (79).
POWER CONNECTOR LOCATED ON
FRONT, LEFT HAND SIDE OF UNIT.
9 | FE46 Elliptical |
|