Step 10
Locate the POLAR RECEIVER (#16). Slide the
FOAM ISOLATOR (#15) over the POLAR
RECEIVER. Remove the POLAR RECEIVER
JACK (G) from the tape and plug the POLAR
RECEIVER into the POLAR RECEIVER JACK.
Step 11
Locate the front and back MONOCOLUMN COVERS (#5 & #6). With the wire positioned on top, carefully insert the POLAR RECEIVER (#16) between the vertical ribs located inside the BACK MONOCOLUMN COVER (#6).
Place the BACK MONOCOLUMN COVER (#6) over the PIVOT SHAFT (H) at the top of the MONOCOLUMN (F).
NOTE: THE POLAR RECEIVER WIRE MUST BE POSITIONED ON TOP WHEN INSERTED INTO THE REAR MONOCOLUMN COVER (#6).
REMARQUE : LE FIL DU RÉCEPTEUR POLAR DOIT ÊTRE PLACÉ SUR LE DESSUS LORS DE L'INSERTION DANS LE CACHE ARRIÈRE DE LA COLONNE CENTRALE (Nº 6).
Step 12
Place the FRONT MONOCOLUMN COVER (#5) on the opposite side of the BACK MONOCOLUMN COVER (#6) to cover the PIVOT SHAFT (G) and CONSOLE SUPPORT ASSEMBLY MOUNTING SCREWS. Interlock the top tabs and use two PHILLIPS PAN HEAD SCREWS (#3) to secure the bottoms of MONOCOLUMN COVERS together. Tighten the screws securely.
CAUTION: DO NOT
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES VIS CRUCIFORMES À TÊTE CYLIN- DRIQUE (Nº 3).
Step 13
Locate one FRONT ROCKER COVER (#13) and one BACK ROCKER COVER (#14). Position the FRONT ROCKER COVER over the user side of the left end of the PIVOT SHAFT (H) (as shown) making sure that it interlocks with the MONOCOLUMN COVERS (#5 & #6). Place the BACK ROCKER COVER over the opposite side of the left end of the PIVOT SHAFT in the same manner. Secure the covers using three PHILLIPS PAN HEAD SCREWS (#3). Repeat the procedure reversing front and back for the user right end of the pivot shaft.
CAUTION: DO NOT
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES VIS CRUCIFORMES À TÊTE CYLIN- DRIQUE (Nº 3).