Life Fitness CL5X manual

Page 7

7.Attach the 4-PIN (4P), 3-PIN (3P), and 16-PIN (16P) CON- NECTORS to the corresponding JACKS on the back of the CONSOLE ASSEMBLY (#4).

8.Feed any excess WIRE HARNESS (E) down into the CONSOLE SUPPORT ASSEMBLY (#7). Secure the CON- SOLE ASSEMBLY (#4) to the CONSOLE SUPPORT ASSEMBLY using four PHILLIPS PAN HEAD SCREWS (#2). Tighten the SCREWS securely.

CAUTION: Do not over-tighten the PHILLIPS HEAD PAN SCREWS (#2).

CAUTION: Be careful not to pinch the WIRE HARNESS

(E) when assembling the CONSOLE ASSEMBLY (#4) to the CONSOLE SUPPORT ASSEMBLY (#7).

9.Locate and install the CONSOLE SUPPORT CAP (#19) onto the CONSOLE SUPPORT ASSEMBLY (#7) as shown.

10.Locate the POLAR RECEIVER (#16). Slide the FOAM ISOLATOR (#15) over the POLAR RECEIVER. Remove the POLAR RECEIVER JACK (G) from the tape and plug the POLAR RECEIVER into the POLAR RECEIVER JACK.

11.Locate the FRONT and BACK MONOCOLUMN COVERS (#5 & #6). With the WIRE positioned on top, carefully insert the POLAR RECEIVER (#16) between the vertical ribs located inside the BACK MONOCOLUMN COVER (#6).

Place the BACK MONOCOLUMN COVER (#6) over the PIVOT SHAFT (H) at the top of the MONOCOLUMN (F).

NOTE: The POLAR RECEIVER WIRE must be positioned on top when inserted into the REAR MONOCOLUMN COVER (#6).

12.Place the FRONT MONOCOLUMN COVER (#5) on the opposite side of the BACK MONOCOLUMN COVER (#6) to cover the PIVOT SHAFT (G) and CONSOLE SUPPORT ASSEMBLY MOUNTING SCREWS. Interlock the top tabs and use two PHILLIPS PAN HEAD SCREWS (#3) to secure the bottoms of the MONOCOLUMN COVERS together. Tighten the SCREWS securely.

CAUTION: Do not over-tighten the PHILLIPS PAN HEAD SCREWS (#3).

13.Locate one FRONT ROCKER COVER (#13) and one BACK ROCKER COVER (#14). Position the FRONT ROCKER COVER over the user side of the left end of the PIVOT SHAFT (H) (as shown) making sure that it inter- locks with the MONOCOLUMN COVERS (#5 & #6). Place the BACK ROCKER COVER over the opposite side of the left end of the PIVOT SHAFT in the same manner. Secure the COVERS using three PHILLIPS PAN HEAD SCREWS (#3). Repeat the procedure reversing front and back for the user right end of the PIVOT SHAFT.

CAUTION: Do not over-tighten the PHILLIPS PAN HEAD SCREWS (#3).

7

Image 7
Contents Classic Series Cross-Trainer Model Clsx Congratulations Important Safety Instructions Page Please Read this Prior to Assembly Page Page PRE-OPERATION Checklist Instructions DE Montage Félicitations Consignes DE Securite Importantes Page Ceau Électrique Principal Mise EN Garde NE Serrez PAS Trop LES VIS Nº Prise Dimensions Hors Tout Instrucciones DE Montaje Felicitaciones ¡INSTRUCCIONES Importantes DE Seguridad Page LEA POR Favor Antes DE Proceder AL Montaje Columna Central Page Medidas Físicas