ProForm PFTL54806.0 user manual Information Mode, Optional Chest Pulse Sensor

THE INFORMATION MODE

The console features an information mode that keeps track of treadmill usage information. The information mode also allows you to select miles or kilometers as the unit of measurement and to turn on and turn off the demo mode.

To select the information mode, hold down the Stop button, insert the key into the console, and then release the Stop button. When the information mode is se- lected, the following information will appear in the dis- play:

The center of the display will show the total number

of miles or kilo-

meters that the

walking belt has moved. The lower right part

of the display will

show the total number of hours that the treadmill has been operated. In addition, an “E” for English miles or an “M” for metric kilometers will appear in the lower part of the display. To change the unit of measurement, press the Speed increase button.

IMPORTANT: If a “d” appears in the display, the con- sole is in the “demo” mode. This mode is intended to be used only when a treadmill is displayed in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the indicators in the display will automati- cally appear in a preset sequence; the buttons on the console will not operate. If a “d” appears when the in- formation mode is selected, press the Speed de- crease button so that the “d” disappears.

To exit the information mode, remove the key from the console.

THE OPTIONAL CHEST PULSE SENSOR

An optional chest pulse sensor offers hands-free oper- ation as it tracks your heart rate during your workouts.

To purchase the optional chest pulse sensor, call the toll-free telephone number on the front cover of this manual.

If you purchase the optional chest pulse sensor, follow the steps below to install the receiver in- cluded with the chest pulse sensor.

1.Make sure that the key is removed from the con- sole and that the power cord is unplugged.

Remove the indicated Console Screw (4) and the Access Door (73) from the back of the Console

2.Connect the wire on the receiver (A) to the indicated wire extending from the Console (91). Hold the re- ceiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door

(73)with the two included small screws.

3.Make sure that no wires are pinched. Reattach the Access Door (73) with the Console Screw (4). Discard the other wires included with the receiver.

91		Wire	Small
		Screws
73
	4	A	Small
			Cylinder

17