ProForm PFTL512040 user manual

2.Press the two Base Endcaps (99) (only one is shown) into the Base (109). Make sure that the angle of each Base Endcap matches the angle of the Base, as shown in the inset drawing.

Attach two Base Pads (100) (only one is shown) to the bottom of the Base (109) near the two Endcaps (99) with four 3/4” Tek Screws (47). Note: There are no screw holes in the Base Endcaps. Press firmly on the screw- driver when tightening the Tek Screws.

With the help of a second person, carefully tip the tread- mill so the four Base Pads (100) are resting on the floor.

3.Attach a Wheel (108) to each Wheel Housing (106) (only one is shown) with a Wheel Bolt (107) and a Wheel Nut (21). Make sure that the Wheel Bolts are inserted from the sides shown. Do not overtighten the Wheel Bolts.

4.Identify the left handrail, which has a hole in the indicated location, and the right handrail. Hold the right handrail near the Right Upright (82). Insert the Wire Harness (83) into the large hole in the right handrail and out of the upper end as shown.

Next, hold the right handrail against the Right Upright (82). Tighten a 4” Bolt (112) three to four turns into the Right Upright and the lower end of the right handrail. Tighten two 5/16” x 1” Bolts (122) into the upper end of the right handrail and the Right Upright. Be careful not to drop the Bolts into the handrail. If necessary, raise or lower the handrail to thread the 5/16” x 1” Bolts into the Upright. Firmly tighten all three Bolts.

Attach the left handrail to the Left Upright (81)as de- scribed above. Note: There is not a wire harness in the Left Upright.

Press two Upright Endcaps (69) into the upper ends of the Uprights (81, 82). Make sure that the notches in the Upright Endcaps are up as shown. If necessay, tap the Endcaps with rubber mallet.

2			109
	99
	100	47
			99	109
	21
3
	107
	108
		21
			82
			21
				108
				107
			106
4		Notch
	122
			69
	Left
Handrail			83	Notch
		81	122
	Hole		Right
		112	Handrail	69
				82
				112

7