ProForm PFTL49621.0 Make sure that the power cord is unplugged, Do not fully fold the Frame yet

1.	Make sure that the power cord is unplugged.	1		Hole
	With the help of a second person, carefully tip				90
	the treadmill onto its left side. Partially fold the					5
	Frame (55) so that the treadmill is more stable;
	do not fully fold the Frame yet.
	Cut the shipping tie securing the Upright Wire				95
	(87) to the Base (95). Locate a plastic tie in the
	indicated hole in the Base, and use the tie to pull
	the Upright Wire out of the hole.	55	94 90	5
	Attach two Base Feet (90) to the Base (95) in the
	locations shown with two #8 x 1" Tek Screws (5)
	and two Base Foot Spacers (94).				90 5
	Then, attach the other two Base Feet (90) with
	two #8 x 1" Tek Screws (5).
			94	90
2. See the inset drawing. Cut the plastic tie near		2
	the Upright Wire (87).		Plastic Tie		89
	Attach a Wheel (96) to the Base (95) with a 3/8"
	x 2" Bolt (8) and a 3/8" Nut (10). Do not over-			87
	tighten the Nut; the Wheel must turn freely.
	Press a Base Cap (89) into the Base (95).	8
			10 96	95
					87Cut
		7