ProForm PFTL49400 user manual Assembly, Handrail Bolt yet

Handrail Washer (16)Ð2

Handrail Nut (57)Ð2

3/8" Washer (70)Ð2

3/4" Screw (13)Ð2

Console Screw Ð4

3 1/2" Handrail Bolt (89)Ð2

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walk- ing belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1.With the help of a second person, carefully raise the Uprights (14), Right Handrail (32), and the Console Base (6) until the treadmill is in the position shown. Be careful not to pull on the Wire Harness (26). Set the Right Handrail on the right Upright until step 2 is completed.

Refer to the inset drawing. Insert one of the Extension Legs (41) into the treadmill as shown. (Note: It may be helpful to tip the Uprights [14] in the direction shown by the arrow as you insert the Extension Leg.) Make sure that the Base Pad (36) is on the bottom of the Extension Leg. Attach the Extension Leg with an Extension Leg Screw

(34).Be sure to push on the head of the Extension Leg Screw while tightening it.

Attach the other Extension Leg (41) in the same way.

2.Position the Left Handrail (2) on the left Upright (14) as shown. Thread a Handrail Bolt (15) with a Handrail Washer

(16)into the left Upright and the Left Handrail. Do not tighten the Handrail Bolt yet.

Attach the lower end of the Left Handrail (2) to the Extension Leg (41) with a 3 1/2Ó Handrail Bolt (89), a 3/8Ó Washer (70), and a Handrail Nut (57). Do not tighten the

Handrail Bolt yet.