TROUBLE-SHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll- free at
1.SYMPTOM: THE POWER DOES NOT TURN ON
a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) Use only a
b.After the power cord has been plugged in, make sure that the key is fully inserted into the console. See step 1 on page 8.
c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
c |
|
Tripped | Reset |
a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console. See step 1 on page 9.
d. If the treadmill still will not run, please call our Customer Service Department,
3.SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY
a. Remove the key from the console and UNPLUG THE POWER |
|
| |
CORD. Remove the screws from the hood. Carefully remove the | 1/8” |
| |
hood. Locate the Reed Switch (21) and the Magnet (43) on the | 42 | ||
left side of the Pulley (42). Turn the Pulley until the Magnet is | 76 | ||
| |||
aligned with the Reed Switch. Make sure that the gap between | 21 | 43 | |
the Magnet and the Reed Switch is about 1/8”. If necessary, |
|
| |
loosen the Reed Switch Screw (76) and move the Reed Switch | Top |
| |
slightly. Retighten the Screw. |
| ||
treadmill for a few minutes to check for a correct speed reading. | View |
|
11