Assembly

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.


Assembly requires the included allen wrench		and your own phillips screwdriver		,
adjustable wrench	, and a rubber mallet		.

1.Note: Use the PART IDENTIFICATION CHART in the center of this manual to identify small parts used during assembly.

Do not plug in the power cord until all assembly steps are completed.

With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (51) so that the treadmill will be more stable. Do not fully fold the treadmill until it is completely as- sembled.

Attach the six Base Pads (44) to the bottom of the Base (116) with six 1” Tek Screws (13). Note: Only three Tek Screws are shown.

2.Identify the Right and Left Uprights (55, 64); the Left Upright has two small holes near the square post.

Hold the Right Upright (55) near the Base (116), and ori- ent the Right Upright as shown. Make sure that the

Right Upright bends in the direction shown. Straighten the Wire Harness (49), and feed it into the lower end of the Right Upright and out of the upper end. Hand tighten two Upright Bolts (112) with Washers (111) into the bottom of the Base (116) and the lower end of the Right Upright.

Attach the Left Upright (64) as described above. Note: There is not a wire harness on the left side.

1
	51
13	44
	44
	116
		44
	13
2	116
	116	55
	Holes	55
	Bend
112 111

3.With the help of a second person, carefully tip the tread- mill back down so that the Uprights (55, 64 [not shown]) are vertical. Make sure that the end of the Wire

Harness (49) does not fall into the Right Upright.

Set the Console Base (38) on the Right Upright (55) as shown. Check the pins in the connector on the Wire Harness (49) and make sure that they are straight. Connect the Wire Harness to the indicated connector on the back of the Console Base. Be sure to insert the connectors properly (see the inset drawing). The con- nectors should slide easily and “snap” into place. If the connectors do not slide easily and snap into place, turn a connector and try again.

3
38	49
	49
55

ASSEMBLY

Assembly requires the included allen wrench

Harness (49) does not fall into the Right Upright.