ProForm PFTL59506.0 user manual Wire

Page 8

5.Attach the Latch Housing (73) to the left Upright (84) with two Screws (50); start both Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.

Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (73). Then, tighten the knob onto the pin.

5

84

73

Knob

Spring

3

Large Hole

Collar

Pin

6.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is used to adjust the walking belt (see page 20).

If you purchase the optional chest pulse sensor (see page 16), follow the steps below to install the receiver included with the chest pulse sensor.

1.Make sure that the key is removed from the console and that the power cord is un- plugged.

Remove the indicated Screw (3) and the Access Door (76) from the back of the Console Base (85).

2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base

(85). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (76) with the two included small screws.

3.Make sure that no wires are pinched. Reattach the Access Door (76) with the Screw (3). Discard the other wires included with the receiver.

85

 

Wire

 

Small

 

 

 

 

Screws

76

 

 

 

3

A

 

Small

 

 

 

 

Cylinder

8

Image 8
Contents Call TOLL-FREE QUESTIONS?Model No. PFTL59506.0 Serial No Table of Contents Important Precautions Page Back Before YOU BeginRight Side Assembly Make sure that the power cord is unpluggedBe careful to avoid pinching the wires. While Bolts and then firmly tighten themWire PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeWhenkey. you are finished exercising, remove Measure your heart rate if desiredTurn on the fan if desired HOW to USE a Preset Program Select a preset programHOW to USE a Calorie Program Select a calorie programFollow your progress with the display Information MODE/DEMO Mode Optional Chest Pulse SensorHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Top Conditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches R0307A Qty DescriptionExploded Drawing a Exploded Drawing B-Model No. PFTL59506.0 R0307A Exploded Drawing C-Model No. PFTL59506.0 R0307A Exploded Drawing D-Model No. PFTL59506.0 R0307A Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty