Assembly

Assembly requires two persons. Set the treadmill in a cleared area, and remove all packing materials except for the plastic ties around the upper body arms. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.


Assembly requires the included allen wrench		and your own phillips screwdriver		,
adjustable wrench	, and a rubber mallet		.

Note: Use the PART IDENTIFICATION CHART in the center of this manual to identify small parts used during assembly.

Do not plug in the power cord until all assembly steps are completed.

1.With the help of a second person, carefully tip the tread- mill onto its left side as shown. Partially fold the Frame (51) so that the treadmill will be more stable. Do not fully fold the treadmill until it is completely assembled.

Identify the Right and Left Uprights (55, 64); the Left Upright has two small holes near the square post.

Hold the Right Upright (55) near the Base (116), and ori- ent the Right Upright as shown. Make sure that the Right Upright bends in the direction shown. Straighten the Wire Harness (49), and feed it into the lower end of the Right Upright and out of the upper end. Hand tighten two Upright Bolts (112) with Star Washers (111) into the bottom of the Base (116) and the lower end of the Right Upright.

Attach the Left Upright (64) as described above. Note: There is not a wire harness on the left side.

Note: An extra Base Pad (44) may be included.

2.With the help of a second person, carefully tip the tread- mill back down so that the Uprights (55, 64 [not shown]) are vertical. Make sure that the end of the Wire

Harness (49) does not fall into the Right Upright.

Set the Console Base (38) on the Right Upright (55) as shown. Check the pins in the connector on the Wire Harness (49) to make sure they are straight. Next, con- nect the Wire Harness to the indicated connector on the back of the Console Base. If the connectors do not fit together easily, rotate them and then connect them.

1	116
	116	Holes	55
	Bend	Holes	55
112 111
49			64
			64
111
112	44
	44
2
38	49
55

ASSEMBLY

Assembly requires the included allen wrench

Harness (49) does not fall into the Right Upright.