HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- perature before turning on the power. If you do not do this, the console displays or other electrical components may become damaged.
Plug in the power cord (see |
|
|
|
|
|
|
|
|
|
| |
page 11). Next, locate the |
|
|
|
|
|
reset/off circuit breaker on |
|
|
|
|
|
| Reset | ||||
|
|
|
| ||
the treadmill frame near the |
| Position |
|
|
|
power cord. Switch the cir- |
|
|
|
|
|
|
|
|
|
| |
cuit breaker to the reset po- |
|
|
|
|
|
|
|
|
|
| |
sition. |
|
|
|
|
|
IMPORTANT: The console features a display demo mode, designed to be used if the treadmill is dis- played in a store. If the displays light as soon as you plug in the power cord and switch the circuit breaker to the reset position, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays remain lit, see THE INFORMATION MODE on page 16 to turn off the demo mode.
Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing on page 12) and slide the clip onto the waistband of your clothes.
Then, insert the key into the console. After a moment, the displays will light. IMPORTANT: In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the posi- tion of the clip.
HOW TO USE THE MANUAL MODE
1.Insert the key into the console.
See HOW TO TURN ON THE POWER above.
2.Select the manual mode.
When you insert the key, the manual mode will be selected and a track will appear in the matrix. If a preset work- out has been selected, remove the key and then reinsert it.
3.Start the walking belt.
To start the walking belt, press the Start button, the speed increase button, or one of the speed buttons numbered 1 through 10.
If you press the Start button or the speed increase button, the walking belt will begin to move at 1 mph. As you exercise, change the speed of the walking belt as desired by pressing the speed increase and decrease buttons. Each time you press a button, the speed setting will change by 0.1 mph; if you hold down a button, the speed setting will change in increments of 0.5 mph. Note: After you press the buttons, it may take a moment for the walking belt to reach the selected speed setting.
If you press one of the numbered speed buttons, the walking belt will gradually increase in speed until it reaches the selected speed setting.
To stop the walking belt, press the Stop button. To restart the walking belt, press the Start button, the speed increase button, or one of the speed buttons numbered 1 through 10.
4.Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the Incline increase and de- crease buttons or one of
the numbered incline but- tons. Each time you
press the incline increase or decrease button, the incline will change by 0.5%. If you press one of the numbered incline buttons, the treadmill will adjust to the selected incline setting. Note: After you press the buttons, it may take a moment for the treadmill to reach the selected incline setting.
5. Monitor your progress with the displays.
The matrix—When the
manual mode is se- lected, the matrix will dis- play a
light in succession until
the entire track is lit. The track will then darken and the indicators will again begin to light in succes- sion.
13