Console Diagram, Features of the Console

CONSOLE DIAGRAM

Manual/Program Indicators

Displays

LED Track

Displays

Note: If there is a thin sheet of clear plastic	Key
on the face of the console, remove it.

Speed Buttons

Clip

CAUTION: Before operating the console, read the following precautions.

•Do not stand on the walking belt when turn- ing on the power.

•Always wear the clip (see the drawing above) while operating the treadmill.

•Adjust the speed in small increments in order to avoid sudden jumps in speed.

•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and place only a sealed water bottle in the water bottle holder.

FEATURES OF THE CONSOLE

The treadmill console offers an impressive array of features to help you get the most from your exercise. When the console is in the manual mode, the speed and incline of the treadmill can be controlled with a touch of a button. As you exercise, the LED track and the four displays will provide continuous exercise feed- back. You can even measure your heart rate using the built-in pulse sensor.

Six certified personal trainer programs are also offered. Each program automatically controls the speed and in- cline of the treadmill as it guides you through an effec- tive workout.

To use the manual mode of the console, follow the steps beginning on page 11. To use a personal trainer program, see page 13.

HOW TO TURN ON THE POWER

1 Plug in the power cord (see page 9).

2	Locate the on/off
	switch on the front of
		On

	the treadmill near the
	the treadmill near the	Position
	power cord. Make sure	Position
	power cord. Make sure
	that the on/off switch is
	in the on position.
	in the on position.

Stand on the foot rails of the treadmill. Find the clip

3 attached to the key (see the drawing at the top of this page), and slide the clip onto the waistband of your clothes. Next, insert the key into the console. After a moment, the displays and various indica- tors on the console will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.