8 Follow your progress with the LED track and the four displays.
See step 5 on page 10.
9 Measure your pulse, if desired.
See step 6 on page 11.
10 Whenkey. the program is finished, remove the
Step onto the foot rails, press the STOP button, and adjust the incline of the treadmill to the lowest level. The incline must be at the lowest level when the treadmill is raised to the storage po- sition or the treadmill will be damaged. Next, remove the key from the console and put the key in a secure place. Note: If the displays and vari- ous indicators on the console remain lit after the key is removed, the console is in the “demo” mode. Refer to the instructions at the right and turn off the demo mode.
When you are finished using the treadmill, move the on/off switch near the power cord to the off position.
THE INFORMATION MODE/DEMO MODE
The console features an information mode that keeps track of the total number of hours that the treadmill has been operated and the total number of miles that the walking belt has moved. The information mode also allows you to switch the console from miles per hour to kilometers per hour. In addition, the information mode allows you to turn on and turn off the demo mode.
To select the information mode, hold down the STOP button while inserting the key into the console. When the information mode is selected, the following informa- tion will be shown:
The DISTANCE/LAPS display will show the total number of miles that the walking belt has moved.
The TIME/INCLINE display will show the total number of hours the treadmill has been used.
An “E” for english miles or an “M” for metric kilometers, will appear in the SPEED/MIN- MILE display. Press the SPEED ▲ button to change the unit of measurement.
IMPORTANT: The CALS./
FAT CALS./PULSE display
should be blank. If a “d” ap- pears in the display, the con- sole is in the “demo” mode. This mode is intended to be
used only when a treadmill is
displayed in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the displays and in- dicators on the console will automatically light in a pre- set sequence, although the buttons on the console will not operate. If a “d” appears in the CALS./FAT
CALS./PULSE display when the information mode is selected, press the SPEED ▼ button so the
CALS./FAT CALS./PULSE display is blank.
To exit the information mode, remove the key from the console.
17