4 Follow your progress with the display.
See step 5 on page 10.
5 Measure your heart rate if desired.
See step 6 on page 11.
6 Turn on the fan if desired.
See step 7 on page 11.
When you are finished exercising, remove the
7 key from the console.
When the program has ended, make sure that the incline of the treadmill is at the lowest set- ting. Next, remove the key from the console and put it in a safe place.Note: If the display remains lit after the key is removed, the console is in the “demo” mode. See page 20 and turn off the demo mode.
When you are finished using the treadmill, switch the reset/off circuit breaker to the off position and unplug the power cord.
HOW TO CREATE CUSTOM PROGRAMS
1 Insert the key into the console.
See HOW TO TURN ON THE POWER on page 10.
2 Select one of the custom programs.
To select a custom pro- gram, press the Program
1or Program 2
button. The words “CUS-
TOM PRO-
GRAM” will appear in the display.
Note: If the custom program has not yet been defined, only three columns of indicators will appear in the matrix in the lower part of the display. If more than three columns of indica- tors appear, see HOW TO USE CUSTOM PRO- GRAMS on page 14.
Press the Start button or the Speed + button
3 and program the desired speed and incline settings.
A moment after the button is pressed, the walking belt will begin to move. Hold the handrails and begin walking.
Refer to the matrix. Each custom program is di- vided into
ment. The speed setting
for the first segment is
shown in the flashing
Current
Segment column of the matrix. (The incline set- tings are not shown in the matrix.) To program a speed setting and an incline setting for the first segment, simply adjust the speed and incline of the treadmill as desired by pressing the Speed and Incline buttons. Every few times a Speed but- ton is pressed, an additional indicator will appear or disappear in the Current Segment column.
When the first segment of the program ends, a se- ries of tones will sound and the current speed set- ting and the current incline setting will be saved in memory. The three columns of indicators will then move one column to the left, and the speed set- ting for the second segment will be shown in the flashing Current Segment column. Program a speed setting and an incline setting for the second segment as described above.
Continue programming speed and incline settings for as many segments as desired; custom pro- grams can have up to forty segments. When you are finished with your workout, press the Stop but- ton twice. The speed and incline settings that you have programmed and the number of segments that you have programmed will then be saved in memory.
When you are finished exercising, remove the
4 key from the console.
See step 7 at the left.
13