Assembly

Assembly requires two persons. Place the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until the treadmill is assembled.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt, the sides of the walking platform, or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt or on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench	and your own phillips screwdriver		.
1. With the help of a second person, carefully raise the		1
Uprights (65) to a vertical position.

Have the second person hold the console assembly near		Console
		Assembly
the Uprights (65) as shown. Look under the console as-

sembly and locate the Console Wire Harness (71).
Cut the plastic ties securing the Upright Wire Harness
(85) to the right Upright (65). Connect the Upright Wire
Harness to the Console Wire Harness (71). Make sure to			71
connect the connectors properly (see the inset draw-
ing). The connectors should slide together easily and			85
snap into place. If the connectors do not slide together
easily and snap into place, turn one connector and try			65
again. IF THE CONNECTORS ARE NOT CONNECTED		71
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
		85

2.Insert the excess Wire Harnesses (71, 85) into the right Upright (65).

Set the console assembly on the Uprights (65). While a second person holds the console assembly, attach the console assembly with four Console Bolts (99) and four Console Washers (69) as shown. Firmly tighten the Console Bolts.

2
Console
Assembly
71, 85
69	69
99	99
65

ASSEMBLY

again. IF THE CONNECTORS ARE NOT CONNECTED