5.Set the Console Base (101) on the Uprights (80, 84). Thread four Upright Bolts (76) with four Internal Star Washers (77) into the Uprights and the Console Base.
Be careful not to pinch the Wires (not shown) in the Uprights. Tighten the two Upright Bolts indicated by the arrows first; then, tighten the other two Upright Bolts.
Make sure that the Left and Right Trays (109, 111) are pressed into the Console Base (101).
6.Fold the treadmill to the storage position (see page 21).
If the Wheels (94) are resting on the floor or if the tread- mill rocks slightly, turn one or both of the Leveling Feet (95) under the Uprights (97) until the Wheels are off the floor and the rocking motion is eliminated. Note: If neces- sary, tip the treadmill and use a phillips screwdriver to turn the Leveling Feet.
5 |
|
| 101 |
|
|
|
|
| |
|
|
|
| 84 |
|
| 111 | 109 |
|
|
|
| 77 |
|
|
| 77 |
|
|
76 |
| 80 | 76 | 77 |
|
|
|
| |
6 |
|
|
|
|
|
|
| 97 |
|
| 94 | 95 |
|
|
|
|
|
| |
|
|
| 94 |
|
7.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet, place a mat under the treadmill. If there are thin sheets of clear plastic on the decals, remove them.
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the receiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (108) and the Access Door (116).
2.Remove the paper from the adhesive pad on the back of the receiver (A). Hold the receiver so the small cylin- der is near the lower edge of the receiver and is fac- ing the Console (107) as shown. Firmly press the re- ceiver onto the indicated corner of the Access Door
(116). Connect the wire on the receiver to the indicated wire extending from the Console.
3.Make sure that no wires are pinched. Reattach the Access Door (116) with the Screw (108). Discard the wires included with the chest pulse sensor.
107 |
Wire |
A |
Wire |
Cylinder |
116 |
108 |
7