Assembly

Make sure that the power cord is unplugged. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal con- dition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver
wire cutters	, and adjustable wrench	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 26 and 27. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. If a part is missing, call toll-free1-888-533-1333.

Base Pad Screw (40)–4		1 3/4” Bolt (76)–2
		1 3/4” Bolt (76)–2
Nut (20)–4
1” Screw (88)–4
		Wheel Bolt (90)–2
Extension Screw (80)–4
Washer (71)–4
Screw (95)–8	3” Bolt (86)–2
1. With the help of a second person, raise the Uprights	1
(97) to the vertical position.	1
(97) to the vertical position.
Insert a Handrail Extension (105) into the post on the left
Upright (97), and align the two small holes in the		81
Handrail Extension with the two small holes in the post.		81
Make sure that the Handrail Extension is oriented so		88
the slot is on top. Tighten two Extension Screws (80)
into the sides of the post; make sure that the Screws are		80
not directly opposite each other.		80
not directly opposite each other.
Next, identify a Left Bottom Handgrip (43), which has a	95		80
			80

large hole for the latch assembly. Hold the Left Bottom	105
Handgrip against the Handrail Extension (105) and the			Hole
post, and tighten two 1” Screws (88) and one Screw (95)	43		Hole
post, and tighten two 1” Screws (88) and one Screw (95)
down into the Left Bottom Handgrip as shown.
down into the Left Bottom Handgrip as shown.
Attach the Left Top Handgrip (81) with three Screws (95)		95	97
inserted through the Left Bottom Handgrip (43).		95
inserted through the Left Bottom Handgrip (43).
Repeat this step on the right side of the treadmill.

ASSEMBLY

Make sure that the Handrail Extension is oriented so