ProForm 831.24745.2 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Make sure that the power cord is unplugged. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal con- dition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver and

adjustable wrench .

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. Extra hardware may be included. If a part is missing, call 1-888-533-1333. To avoid damaging plastic parts, do not use power tools for assembly.

3/4" Screw (10)–5
Base Pad Spacer	3/8" Star	5/16" Star	3/8" Nut (8)–2
	Washer (9)–4	Washer (7)–4
(25)–2
1" Tek Screw (56)–4		3/8" x 2" Bolt (4)–2
5/16" x 1" Bolt (5)–4	3/8" x 4" Bolt (6)–4
1. Make sure that the power cord is unplugged.	1	B
With the help of a second person, carefully tip
			A
the treadmill onto its left side. Partially fold the
Frame (53) so that the treadmill is more stable;
do not fully fold the Frame yet.		Hole	78
Remove and discard the two indicated bolts (A)		80
and the shipping bracket (B).	53		79
Cut the tie securing the Upright Wire (78) to the			56
Base (80). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire			Tie
out of the hole.
Attach a Base Pad (79) to the Base (80) in the	25
location shown with a Base Pad Spacer (25) and		79
a 1" Tek Screw (56). Then, attach another Base		56
Pad (79) with only a 1" Tek Screw (56).
	6