3.Hold one of the Handrails (1) at an angle as shown and fully insert the upper end into the right Upright (11). Keep the lower end of the Handrail away from the treadmill to avoid scratching the finish. Next, rotate the lower end of the Handrail to the position shown by the dotted line. Note: It may be necessary to pull back on the Handrail near the arrow shown in order to position the Handrail against the bracket on the Extension Leg (34).
3a.Refer to drawing 3a. Make sure that the hole in the bracket on the Extension Leg (34) is aligned with the hole in the Handrail (1). If the holes are not aligned, rotate the Handrail away from the treadmill and slide the upper end of the Handrail slightly out of the Upright (11) (see draw- ing 3). Then, rotate the lower end of the Handrail back to the position shown by the dotted line. Repeat, if neces- sary, until the holes are aligned. Make sure that the lower end of the Handrail (see drawing 3a) is against the bracket on the Extension Leg. Tighten a 3/4Ó Screw (25) into the bracket and the Handrail.
Attach the other Handrail (not shown) as described above.
4.Attach the Storage Latch (14) to the left Upright (11) with two Latch Screws (35). Be careful not to overtighten the Latch Screws.
5.Remove the backing from the Adhesive Clip (89). Press the Adhesive Clip onto the right Upright (11) in the indi- cated location. Press the Allen Wrench (88) into the Adhesive Clip.
To protect the floor or carpet, place the Treadmill Mat (91) under the treadmill.
6.Make sure that all parts are tightened before you use the treadmill.
6
3 |
|
| 11 |
| 1 |
Bracket |
|
| 34 |
3a |
|
| 25 |
| Bracket |
1 | 34 |
| |
4 |
|
| 35 |
11 | 14 |
| |
5 |
|
| 11 |
| 91 |
| 88 |
| 89 |