ProForm Crosswalk 397 user manual See the inset drawing. Tie the wire tie

4. Identify the Right Upright (76), which is marked	4
“Right.” Have a second person hold the Right
Upright near the Base (74).			63
See the inset drawing. Tie the wire tie in the
Right Upright (76) securely around the end of
the Upright Wire (63). Then, insert the Upright
Wire into the lower end of the Right Upright as		63	76
you pull the other end of the wire tie through the	Wire Tie
Right Upright.
				Wire
				Tie
			76
		74
5. Hold the Right Upright (76) against the Base	5
(74). Be careful not to pinch the Upright Wire
(63).			76
Insert a 3/8" x 3 1/4" Screw (2) with a 3/8" Star
Washer (3) into the top hole in the Right Upright
(76). Then, partially tighten the Screw into the
Base (74).
Partially tighten two more 3/8" x 3 1/4" Screws
(2) with two 3/8" Star Washers (3) into the Right				3
Upright (76) and the Base (74); do not fully
tighten the Screws yet.
Attach the Left Upright (not shown) in the			63
same way. Note: There are no wires on the left				2
side.		74	3
	8