6.Identify the Left and Right Handrails (59, 64), which are marked “Left” and “Right.” Remove the four 5/16" x 3/4" Screws (5) and four 5/16" Star Washers (6) from the bottoms and sides of each Handrail.
Hold the Right Handrail (64) near the Right Upright (76). Insert the wire tie on the Upright Wire (63) through the hole in the bottom and out of the hole in the side of the Left Handrail as shown. Then, pull the Upright Wire through the Right Handrail.
Attach the Right Handrail (64) to the Right Upright (76) with two of the 5/16" x 3/4" Screws
(5) and two of the 3/8" Star Washers (6) that you just removed. Make sure not to pinch the
Upright Wire (63). Start both Screws, and then tighten them.
Attach the Left Handrail (59) to the Left Upright
(66)as described above. Note: There are no wires on the left side.
6
|
| 63 | 5, 6 |
|
|
| |
|
| 6 | 64 |
|
|
| |
| 5, 6 | 5 |
|
|
|
| |
|
|
| 6 |
6 | 59 |
| 5 |
|
|
| 76 |
5 | 6 |
| |
| 5 |
| 66 |
7. Position the Console Crossbar (61) between | 7 |
|
|
|
the Left and Right Handrails (59, 64) with |
|
|
| |
|
|
|
| |
the Console Ground Wire (47) positioned as |
| 6 |
|
|
shown. |
|
|
| |
Attach the Console Crossbar (61) to the Left | 47 | 5 |
| 64 |
and Right Handrails (59, 64) with the other four | 61 |
|
|
|
5/16" x 3/4" Screws (5) and the other four 5/16" | 6 |
| 5 | 6 |
Star Washers (6) that you removed in step 6. |
| |||
Start all four Screws, and then tighten them. | 5 |
|
|
|
| 59 |
|
|
|
9