ProForm 831.299253 user manual

Page 7

3.Locate the plastic tie in the post on the left Upright (82). Hold a Handrail Extension (85) in the position shown. Insert the plastic tie into the Handrail Extension as you insert the Handrail Extension into the post. Attach the Handrail Extension with three short Screws (76). Note: The plastic tie is tied to the Pulse Wire (125). Do not dam- age the Pulse Wire. The Pulse Wire is used with the optional chest pulse sensor (see page 18).

Slide a Handrail Foam Grip (110) onto the Handrail Extension (85). If it is difficult to slide on the Foam Grip, place a small amount of warm water and dish soap in the Foam Grip. There may be one or two holes in the bottom of the Foam Grip. Press a Plastic Fastener (47) into each hole.

Attach the other Handrail Extension and Handrail Foam Grip to the right Upright (not shown). Note: There is not a pulse wire in the right Upright.

4.Make sure that the Lock Knob Sleeve (111) is fully in- serted into the left Upright (82).

Remove the Lock Knob (102) from the Lock Pin (115). Make sure that the Lock Pin Collar (113) and the Spring (112) are on the Lock Pin. Insert the Lock Pin into the left Upright (82) and tighten the Lock Knob onto it.

5.Refer to figure 5a. Look at the left Rear Foot (59) at the back of the treadmill. If the left Rear Foot touches the floor, go to step 6. If there is a space between the left Rear Foot and the floor, follow the instructions below.

Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 19.

Refer to figure 5b. Using a phillips screwdriver, remove the Screw (60), the Rear Foot (59) Rear Foot Spacer (11) from the right side. Reattach the right Rear Foot with the Screw. Hold the treadmill firmly with both hands, and lower the treadmill as described on page 19.

Check the left Rear Foot again (not shown). If the left Rear Foot is still off the floor, raise the treadmill and re- move the left Rear Foot. Snap the Rear Foot Spacer (120) onto the left Rear Foot and reattach the Rear Foot and Spacer to the treadmill. Carefully lower the treadmill.

3

 

 

 

 

 

76

Post

 

 

 

Plastic Tie

 

125

 

110

 

 

 

 

 

85

76

 

 

 

82

47

 

 

 

4

 

 

 

 

82

 

102

 

 

112

 

 

113

 

 

 

 

 

 

115

 

 

 

111

5a

 

 

 

59

 

 

 

5b

 

 

 

60

 

 

 

59

120

 

 

 

 

6.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet from damage, place a mat under the treadmill.

7

Image 7
Contents SEARS, Roebuck and CO. Hoffman ESTATES, IL Model No Serial NoTable of Contents Important Precautions Page Left Side Before YOU BeginRight Side Your own phillips screwdriver AssemblyExtension Legs 103 remain in the Uprights Page HOW to Plug in the Power Cord Operation and AdjustmentPerformant Lubetm Walking Belt Features of the Console Diagram of the ConsoleHOW to USE the Manual Mode SPEED/MIN-MILE CALORIES/FAT CaloHOW to Connect Your Portable Stereo HOW to Connect Your Computer HOW to Connect Your Home StereoPress the Mode button HOW to Connect Your VCRPressVCR. the Play button on your CD player or Select a program HOW to USE Programs Directly from OUR Internet SiteProgram Whenkey. the program is finished, remove Information MODE/DEMO ModeRIES/ FAT CALORIES/PULSE display is blank Optional Chest Pulse Sensor Optional Hand WeightsHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Move the TreadmillProblem The power turns off during use TROUBLE-SHOOTINGTop 3ÓÐ4Ó Problem The walking belt slows when walked onExercise Intensity Conditioning GuidelinesWorkout Guidelines Key Qty Description No. Qty Part LISTÑModel NoExploded DRAWINGÑModel No 107 101 20 97 121 103 128 100 126 104 Model No Full 90 DAY WarrantySEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL