ProForm 831.297782 HOW to USE the Chest Pulse Sensor, HOW to PUT on the Chest Pulse Sensor

Page 7

HOW TO USE THE CHEST PULSE SENSOR

The state-of-the-art chest pulse sensor allows you to continuously monitor your heart rate while you exercise. Follow the instructions below to use the chest pulse sensor.

HOW TO PUT ON THE CHEST PULSE SENSOR

The chest pulse sensor consists of two components: the chest strap and the sensor unit.

Chest Strap

Buckle

Sensor Unit

Tab

 

Refer to the inset drawing above. Insert one of the tabs on the chest strap through one end of the sensor unit. Press the end of the sensor unit under the buckle on the chest strap. The tab should be flush with the front of the sensor unit.

Wrap the chest

 

strap around

 

your chest and

 

attach the free

 

end of the chest

 

strap to the

 

sensor unit.

Logo

Adjust the length

of the chest

 

strap, if neces-

 

sary. The chest

 

pulse sensor

 

should be under

 

your clothing, tight against your skin, and as high under the pectoral muscles or breasts as is comfortable. Make sure that the logo on the sensor unit is facing forward and is right-side-up.

Next, pull the sensor unit away from your body a few inches and locate the two electrode areas on the inner side. The electrode areas are the areas covered by

shallow ridges. Using saline solution such as saliva or contact lens solution, wet both electrode areas. Return the sensor unit to a position against your chest.

CARE AND MAINTENANCE

¥Thoroughly dry the chest pulse sensor after each use. The chest pulse sensor is activated when the electrode areas are wetted and the chest pulse sensor is put on; the chest pulse sensor shuts off when it is removed and the electrode areas are dried. If the chest pulse sensor is not dried after each use, it may remain activated longer than necessary, draining the battery prematurely.

¥Store the chest pulse sensor in a warm, dry place. Do not store the chest pulse sensor in a plastic bag or other container that may trap moisture.

¥Do not expose the chest pulse sensor to direct sunlight for extended periods of time; do not expose it to temperatures above 122¡ Fahrenheit (50¡ Celsius) or below 14¡ Fahrenheit (-10¡ Celsius).

¥Do not excessively bend or stretch the sensor unit when using or storing the chest pulse sensor.

¥Clean the sensor unit using a damp clothÑnever use alcohol, abrasives, or chemicals. The chest strap may be hand washed and air dried.

CHEST PULSE SENSOR TROUBLE-SHOOTING

The instructions beginning on page 10 explain how the chest pulse sensor is used with the console. If the letters ÒPLSÓ appear in the CALS./FAT CALS./ PULSE display or if the displayed heart rate is excessively high or low, try the steps below.

¥Make sure that the chest pulse sensor is under your clothing, tight against your skin, and as high under the pectoral muscles or breasts as is comfortable. The logo on the sensor unit must be facing forward and be right-side-up. Note: If the chest pulse sensor does not function when positioned as described, try moving it slightly lower or higher on your chest.

¥Use saline solution such as saliva or contact lens solution to wet the two electrode areas on the sensor unit. If heart rate readings do not appear until you begin perspiring, re-wet the electrode areas.

7

Image 7
Contents SEARS, Roebuck and CO., Hoffman ESTATES, IL Model No Serial NoImportant Precautions Table of ContentsThere is one Left Right Side Before YOU BeginAssembly requires the included allen wrench AssemblyPhillips Page Chest Pulse Sensor TROUBLE-SHOOTING HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor Care and MaintenanceBattery ¥ The CR 2032 battery may need to be replacedHOW to Plug in the Power Cord Operation and AdjustmentPerformant Lubetm Walking Belt Features of the Console Diagram of the ConsoleMake sure that Position On/off switch is ÒonÓ position HOW to Turn on the PowerHOW to USE the Manual Mode DISTANCE/LAPS CALS./FAT CalsSelect the desired speed program HOW to USE the Speed ProgramsPress the Start button to start the program Select the desired heart rate program HOW to USE the Heart Rate ProgramsSelect the Fitness Test program HOW to USE the Fitness Test ProgramFollow your progress with the LED track Treadmill is set at 1.5%. Remove the keyPage Hold down STOP/PAUSE button for two Seconds HOW to Create a Custom ProgramInsert the key into the console Select one of the custom programsPress the Start button HOW to USE a Custom ProgramWhen the program is completed, remove the key HOW to Select the Information ModeHOW to Adjust the Firmness of the Walking Platform HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE HOW to Move the TreadmillProblem The power turns off during use Maintenance and TROUBLE-SHOOTINGCR 2032 battery may need to be replaced Problem The heart rate monitor does not function properlyExercise Intensity Conditioning GuidelinesWorkout Guidelines Suggested Stretches Key No. Qty Description Part LISTÑModel No8Ó White Wire, Male/Female Page Exploded DRAWINGÑModel No Model No Full 90 DAY WarrantySEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL