CONSOLE DIAGRAM
Note: If there is a thin sheet of |
| Key |
plastic on the console, remove it. |
|
|
| ||
|
|
|
Clip
|
| If the Start button or the Speed increase button is | |||||
|
|
|
|
|
| pressed, the walking belt will begin to move at 1 | |
Note: To prevent damage to the walking platform, |
| mph. As you exercise, change the speed of the | |||||
always wear clean shoes when using the treadmill. |
| walking belt as desired by pressing the Speed in- | |||||
|
|
|
|
|
| crease and decrease buttons. Each time a button | |
Before operating the console, make sure that the |
| is pressed, the speed setting will change by 0.1 | |||||
power cord is properly plugged in (see page 11). |
| mph; if a button is held down, the speed setting | |||||
In addition, locate the |
|
|
|
|
| will change in increments of 0.5 mph. Note: After | |
reset/off circuit breaker on |
|
|
|
|
| the buttons are pressed, it may take a moment for | |
|
|
|
|
| |||
the treadmill frame near the |
|
|
|
|
| the walking belt to reach the selected speed setting. | |
power cord, and make sure |
|
|
|
|
|
| |
| Reset |
|
|
|
| ||
that the circuit breaker is in |
|
|
|
| If one of the numbered speed buttons is pressed, | ||
|
|
|
|
| |||
|
|
|
|
| |||
the reset position. |
|
|
|
|
| the walking belt will gradually change in speed until | |
|
|
|
|
| |||
|
|
|
|
|
| it reaches the selected speed setting. | |
Next, stand on the foot rails of the treadmill. Find the |
|
| |||||
clip attached to the key (see the drawing above), and |
| To stop the walking belt, press the Stop button. | |||||
slide the clip onto the waistband of your clothes. Then, |
| The elapsed time will begin to flash in the display. | |||||
insert the key into the console. After a moment, the |
| To restart the walking belt, press the Start button, | |||||
display will light. Important: In an emergency situa- |
| the Speed increase button, or one of the numbered | |||||
tion, the key can be pulled from the console, caus- |
| speed buttons. | |||||
ing the walking belt to slow to a stop. Test the clip |
|
| |||||
by carefully taking a few steps backward; if the key |
| Note: The first time the treadmill is used, observe | |||||
is not pulled from the console, adjust the position |
| ||||||
| the alignment of the walking belt, and center the | ||||||
of the clip. |
|
|
|
|
| ||
|
|
|
|
| walking belt if necessary (see page 17). | ||
|
|
|
|
|
| ||
Follow the steps below to operate the console. |
| Change the incline of the treadmill as desired. | |||||
3 | |||||||
|
|
|
|
| |||
1
2
Insert the key into the console.
A moment after the key is inserted, the display will light.
Start the walking belt.
To change the incline of the treadmill, press either of the Incline buttons. Each time a button is pressed, the incline setting will change by 0.5%. Note: After the buttons are pressed, it may take a moment for the treadmill to reach the selected in- cline setting.
To start the walking belt, press the Start button, the Speed increase button, or one of the speed buttons numbered 1 to 10.
12