ProForm PFTL39920 user manual Assembly, Pliers, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver	,
rubber mallet	, wire cutters	, adjustable wrench	, and needlenose
pliers	.

To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.

1.Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the treadmill onto one side. Partially fold the Frame (75) so that the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.

Attach four Base Pads (40) to the Base (11) with four 1” Tek Screws (119).

2.With the help of a second person, tip the treadmill down to the position shown.

Attach a Wheel (37) to each side of the Base (11) with a Wheel Bolt (36) and a Wheel Nut (38) as shown. Do not over tighten the Bolt. The Wheel should be able to spin freely.

Identify the Right Handrail (103) (the Handrail Wire Harness [21] is routed through the Right Handrail). If there are plastic ties in the lower end of the Right Handrail, remove them. While a second person holds the Right Handrail near the Base Wire Harness (99), connect the Handrail Wire Harness to the Base Wire Harness. If the connectors do not fit together easily, rotate them and then connect them.

1			40
			119
75
	40
			119
			40
11			119
2
			103
		99	21
			11
	38		37
		36

5