Wayne-Dalton 3014 installation instructions Opener Models, Photoelectric Safety Sensors, Jumper

Wayne-Dalton Corp.

P.O. Box 67 Mt. Hope, OH 44660

(888)827-3667

www.wayne-dalton.com

Photoelectric Safety Sensors

Installation Instructions

and Owner’s Manual

Opener Models:

Torsion idrive™ models: 3651-372, 3750-372.

Quantum™/Classicdrive™ models: 3012, 3014, 3016, 3018, 3212, 3213, 3214, 3312, 3313, 3314, 3316, 3412, 3414, 3512, 3514.

DoorMaster™ models: BDOR-2000 & BIRW-2000

idrive™ models: 3660-372, 3661-372, 3662-372, 3760-372, 3751-372.

WIRES ARE

PRE-ATTACHED

	Photoelectric Sensors Hardware: 297218
	(2) 5/16 x 1-1/2” Lag Screws
	(2) 1” Flat Head Nails
Photoelectric Sensors	(2) 1/4-20 x 1/2” Carriage Bolts, Washers & Nuts
(1) Sender w/Wire: 260600	(2) Wall Mounting Brackets
	(2) “U” Brackets
(1) Receiver w/Wire: 260597
	(1) Power Cord Clip (adhesive back)
	(1) Jumper

Important Notice!

DOOR OPENER WILL NOT OPERATE PROPERLY UNTIL PHOTOELECTRIC SENSORS ARE INSTALLED AND PROPERLY ADJUSTED! DO NOT OPERATE DOOR OPENER UNTIL IT IS FULLY INSTALLED, ADJUSTED AND YOU ARE INSTRUCTED TO DO SO!

© Copyright 2003 Wayne-Dalton Corp. Part No: 306736 New 9/4/2003