Inserted PROPERLY, the Console MAY be

5. Loosen the two Crossbar Screws (98) (only one is shown)

several turns. Place the Console Base (87) on the Right

Handrail (16) and the Left Handrail (not shown). Make

sure that the Wire Harness (53) is not pinched by the

Right Handrail. Attach the Console Base with four 3/4”

Screws (5) (only two Screws are shown). Start all four

Screws before tightening any of them.

Insert the Wire Harness (53) through the two indicated

plastic ties on the Console Base (87). Next, insert the

Wire Harness up through the opening beside the Wire

Cover (10). Make sure that the Wire Cover is securely at-

tached to the Console Base.

See the inset drawing. Look at the top of the Console

Base (87). Insert the Wire Harness (53) through the plas-

tic tie on top of the Console Base.

6. Hold the Console (10) near the Console Base (87).

Touch the Right Handrail (16) to discharge any static.

See the inset drawing. Find the 2-wire connector on the

end of the Wire Harness (53). Insert the connector into

the red socket beneath the Console. The connector

should slide in easily and snap into place. If it does

not, turn the connector and then insert it. Insert the 6-

wire connector into the other socket beneath the Console

the same way.

Insert the excess Wire Harness (53) down through the

opening in the Console Base (87) (see the inset drawing

in step 5). Securely tighten the plastic tie on top of

the Console Base to prevent the Wire Harness from

slipping. Then, cut off the end of the plastic tie.

5		87
		87
			53
			10
		Ties
5	98	16
			53
			Tie
			87
6
		53	10
	Ties		87

98	5	5	97
		5

Make sure that the connectors and wires appear as

shown at the right. IF THE CONNECTORS ARE NOT

DAMAGED WHEN THE POWER IS TURNED ON.

See drawing 6a. Press the Bookrack (85) onto the Console

Base (87) in the location shown.

Set the Console (10) on the Console Base (87). Insert

the excess Wire Harness (53) into the large hole in the

side of the Right Handrail (16). Securely tighten the

plastic ties on the bottom of the Console Base to

prevent the Wire Harness from slipping. Then, cut off

the ends of the plastic ties.

Attach the Console (10) to the Console Base (87) with two

3/4” Screws (5) and four 1/2” Screws (97). Start all six

Screws before tightening any of them; do not over-

tighten the Screws. Tighten the two Crossbar Screws

(98) (only one is shown).

536-wire

2-wire