ProForm DTL33940 user manual Console Diagram, STEP-BY-STEP Console Operation

Page 11

CONSOLE DIAGRAM

 

 

 

Displays

 

Note: If there is a thin sheet of

Key

Pulse Sensor

 

plastic on the console, remove it.

Clip

 

CAUTION: Before operating the console, read the following precautions.

Do not stand on the walking belt when turn- ing on the power.

Always wear the clip (see the drawing above) while operating the treadmill.

Adjust the speed in small increments to avoid sudden jumps in speed.

To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and place only a sealed water bottle in the water bottle holder.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 10). The reset/off circuit breaker, located on the treadmill frame near the power cord, should be in the reset position (see page 16).

Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothes.

Insert the key fully into the console. After a moment, the displays will light. Test the clip by carefully tak- ing a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.

Follow the steps below to operate the console.

1 Insert the key fully into the console.

A few seconds after the key is inserted, the dis- plays will light.

Press the Start button or the Speed increase

2 button to start the walking belt.

A moment after the button is pressed, the walking belt will begin to move. Hold the handrails and begin walking.

As you exercise, change the speed of the walking belt as desired by pressing the Speed buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: The console can display speed and distance in either miles or kilometers (see SPEED DISPLAY on page 12). For simplicity, all instructions in this section refer to miles.

11

Image 11
Contents Customer HOT Line QUESTIONS?Model No. DTL33940 Serial No Table of Contents Important Precautions Page Back Before YOU BeginRight Side Make sure that the power cord is unplugged AssemblyIndicated Bolt, but do not tighten the other Bolts yet Page Page Performant Lubetm Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Insert the key fully into the console Console DiagramSTEP-BY-STEP Console Operation Whenkey. you are finished exercising, remove Change the incline of the treadmill as desiredFollow your progress with the three displays Time/Distance Measure your heart rate if desiredHOW to USE the Hand Weights HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Top TroubleshootingProblem The power turns off during use Problem The walking belt slows when walked on Exercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key Qty Description Part LIST-Model No. DTL33940DTL33940 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT HOW to Order Replacement PartsLimited Warranty