Listening to FM and AM Broadcasts
Tuning In a Station |
| |
|
| |
1 When the unit is turned on, | BAND | |
| ||
press TUNER/BAND to | TUNER | |
| ||
select tuner mode. |
| |
The unit tunes in the last station |
| |
tuned in (either FM or AM). |
| |
2 Press TUNER/BAND to | BAND | |
TUNER | ||
select the band, FM or AM. | ||
| ||
Each time you press the button, the |
| |
band selection alternates between |
|
Presetting Stations
You can preset 20 FM and 20 AM stations.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1 Tune in the station you want to preset.
• See “Tuning In a Station” on the left.
2 Press PROGRAM. | PROGRAM |
|
FM and AM. |
|
|
3 Press and hold 4 or ¢ | SEARCH/TUNING | |
|
| |
for more than 1 second. |
|
|
|
| |
|
| |
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the STEREO indicator lights up.
The PROGRAM indicator and “00” start blinking on the display.
3Press PRESET ∞ or 5 (or
REPEAT/PRE DOWN or PRE UP on the remote control) to specify the desired preset number.
PRESET 
REPEAT
To stop searching, press 4 or ¢.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
4Wait a few seconds to confirm the preset number.
• Alternatively, press PROGRAM.
5To preset more stations, repeat the steps above, allocating a different preset number to each station.
When a new station is stored
The station previously memorized with the same preset number is erased. (The frequency of the new station replaces the previous frequency in memory.)
Tuning In a Preset Station
1 Press TUNER/BAND to | BAND |
TUNER | |
select tuner mode. |
|
2Press TUNER/BAND to select the band, FM or AM.
3 Press PRESET ∞ or 5 (or | REPEAT | |
| PRESET | |
REPEAT/PRE DOWN or |
|
|
|
| |
|
| |
PRE UP on the remote |
|
|
control) to select the desired |
|
|
preset number. |
|
|
– 10 –