ProForm DRTL99120 user manual

Page 6

3.Attach the Latch Assembly (82) to the Left Upright (84) with the two Latch Screws (134). Start both Latch Screws before tightening either of them. Note: The Latch Screws may be preattached to the Left Upright.

4.Refer to step 6 and locate the four Upright Bolts (86). Loosen the Upright Bolts three full turns.

With the help of a second person, hold the Console Base (101) near the Uprights (80, 84).

Cut the plastic ties holding the Wire Harness (74) and the pulse wire in the Uprights (80, 84). Connect the Wire Harness and the pulse wire to the connectors on the sides of the Console Base (101). Make sure to connect the connectors properly (see the inset drawings). IF THE CONNECTORS ARE NOT CONNECTED PROP- ERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. The connectors should slide together easily and snap into place. If the con- nectors do not slide together easily and snap into place, turn a connector and try again. Insert the excess Wire Harness and pulse wire up into the Console Base.

Press the Right and Left Top Endcaps (75, 81) into the Uprights (80, 84) as shown.

5.Set the Console Base (101) on the Uprights (80, 84). Attach the Console Base to the each Upright with two Upright Bolts (76) and two Internal Star Washers (77). Be careful not to pinch the Wires (not shown) in the Uprights. Note: Start all four Upright Bolts before tight- ening any of them.

Make sure that the Left and Right Trays (109, 111) are pressed into the Console Base (101).

3

 

 

 

82

 

 

134

 

 

84

 

4

 

 

 

 

Pulse

 

74

Wire

 

101

81

 

75

 

 

80

84

 

 

5

 

101

 

 

84

 

111

109

 

77

77

 

 

 

 

77

76

80

76

6

Image 6
Contents QUESTIONS? Model No. DRTL99120 Serial NoCustomer HOT Line Table of Contents Important PrecautionsPage Before YOU Begin Right SideBack Assembly Legs remain in the UprightsPage 101 127 Operation and Adjustment HOW to Plug in the Power CordPerformant Lubetm Walking Belt Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired Calories/PulseDistance/Incline dis Next, stand on Foot railsHOW to USE Preset Programs Select one of the preset programsPut on the chest pulse sensor HOW to USE Heart Rate ProgramsFollow your progress with the displays Select a heart rate programEnter your age and a maximum speed setting Turn on the fans if desiredChange to the next settings of the CD program Console. However, when the next chirp isNext settings of the CD program Adjust the volume if desiredHOW to Play Music CD’S Follow your progress with the track and the displaysWhenkey. the program is completed, remove HOW to Connect the Treadmill to Your VCR or Computer HOW to Connect the Treadmill to Your ComputerAudio Adapter Cable Press the Play button on your VCR Whenkey. the program is completed removeHOW to USE Programs Directly from OUR WEB Site When the program has ended, remove the keyFollow the on-line instructions to start the program Information MODE/DEMO Mode HOW to Level the Treadmill Optional Chest Pulse SensorChanging the Isolator Springs HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USEProblem The console is too high or too low TroubleshootingProblem The power turns off during use Problem The treadmill rocks during useProblem The walking belt slows when walked on TopWorkout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R0403B Qty DescriptionPart Identification Chart DRTL99120 DRAWINGModelExploded HOW to Order Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT