ProForm 585 PI user manual Trouble-Shooting, Problem The power turns off during use

Page 19

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll- free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the con- sole. See step 1 on page 10.

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position.

PROBLEM: The power turns off during use

c

 

Tripped

Reset

d

 

On

 

Position

 

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the

circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the key from the console. Reinsert the key fully into the console. See step 1 on page 10.

d. Make sure that the on/off switch is in the on position.

e. If the treadmill still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and unplug the

 

 

power cord. Remove the screws from the hood and

1/8”

 

carefully remove the hood. Locate the Reed Switch

42

(21) and the Magnet (43) on the left side of the Pulley

76

(42). Turn the Pulley until the Magnet is aligned with

21

43

the Reed Switch. Make sure that the gap between

 

 

the Magnet and the Reed Switch is about 1/8”. If

Top

 

necessary, loosen the Reed Switch Screw (76) and

 

move the Reed Switch slightly. Retighten the Screw.

View

 

Re-attach the hood, and run the treadmill for a few

 

 

minutes to check for a correct speed reading.

 

 

PROBLEM: The pulse display on the console does not function properly

SOLUTION: a. Wash your hands prior to using the pulse sensor. Clean the sensor with a damp cloth and a little dish soap.

b. Make sure that there is not a bright light or direct sunlight shining directly on the pulse sensor.

19

Image 19
Contents Model No. PFTL59190 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Page Left Side Right Side Before YOU BeginYour own phillips screwdriver AssemblyLegs 103 and Handrails 85 remain in the Uprights HOW to Plug in the Power Cord Operation and AdjustmentPerformant Lubetm Walking Belt Features of the Console Console DiagramSTEP-BY-STEP Console Operation HOW to USE the Manual ModeTIME/INCLINE/MIN-MILE Whenkey. you are finished exercising, remove CALS./FAT CALS./ Pulse display-ThisMeasure your pulse, if desired Speed display-ThisHOW to Connect Your Portable Stereo HOW to Connect Your Computer HOW to Connect Your Home StereoAudio Adapter Cable HOW to Connect Your VCRPress the Program button Finished, remove the key PressVCR. the Play button on your CD player orFollow the on-line instructions to start Program HOW to USE Programs Directly from OUR Internet SiteReturn to the treadmill and stand on the foot Follow your progress with the LED track Four displays Information MODE/DEMO ModeWhenkey. the program is finished, remove HOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Move the TreadmillProblem The power turns off during use TROUBLE-SHOOTINGCD’s and videos are played Problem The walking belt slows when walked onExercise Intensity Conditioning GuidelinesWorkout Guidelines Suggested Stretches Key Qty Description R0101AExploded DRAWING-Model No. PFTL59190 107 108 110 109 111 114 112 102 103 101 116 105 104 100 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT