THE INFORMATION MODE/DEMO MODE
The console features an information mode that keeps track of total number of miles that the walking belt has moved and the total number of hours that the treadmill has been used. The information mode also allows you to switch the console from miles to kilometers. In addi- tion, the information mode allows you to turn on and turn off the demo mode.
To select the information mode, hold down the Stop button while inserting the key into the console. When the information mode is selected, the following informa- tion will be shown:
An “E” for English miles or an “M” for metric kilometers will appear in the Speed dis- play. Press the Speed in- crease button to change the unit of measurement.
The Distance/Incline display will show the total number of miles (or kilometers) that the walking belt has moved.
The Time/Pace display will show the total number of hours the treadmill has been used.
IMPORTANT: The Calories/Pulse display should be blank. If a “d” appears in the display, the console is in the “demo” mode. This mode is intended to be used only when a treadmill is displayed in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the displays and indicators on the console will au- tomatically light in a preset sequence, although the buttons on the console will not operate. If a “d” appears in the Calories/Pulse display when the information mode is selected, press the Speed decrease button so the display is blank.
To exit the information mode, remove the key from the console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor adds even more features to the console. The chest pulse sensor provides
If you purchase the optional chest pulse sensor, follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated 3/4” Screw (6) and the Access Door (94) from the back of the Console Back (95).
| 95 |
Wire |
|
A |
|
Cylinder | 94 |
| 6 |
2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (95). Remove the paper from the adhesive pad on the back of the receiver. Hold the receiver so the small cylinder is near the lower edge of the re- ceiver and is facing the Console Back as shown. Firmly press the receiver onto the indicated corner of the Access Door (94). Note: If there are two screws included with the chest pulse sensor and two plastic posts on the inside of the Access Door, attach the receiver to the plastic posts on the Access Door with the two screws.
3.Make sure that no wires are pinched. Reattach the Access Door (94) with the 3/4” Screw (6). The other
23