STEP 4.
Insert the keypad cable into the oblong hole of the console, and plug it into the board (as shown on the right figure).
Plug in the Interface remote control cable (5- contacts),
Keypad cable
Interface control cable
STEP 5.
Using a #2 Phillips screwdriver, remove the screw that holds in the blank headphone jack cap at the lower front of the display. Retain the screw (You will no longer need the cap and, if desired, you can store it away for any possible future use).
Now take the Entertainment headphone jack from the PVS hardware kit, and plug in the headphone cable to the jack. Use the previously retained screw to reinstall the headphone jack. Tighten snugly.
STEP 6.
Install the center console back to the front display cover and secure with the (4) screws removed in step 3.
Remove the protective paper on the back side of the keypad, and attach it to the console plastic. Be sure to make good alignment between the console plastic and keypad, also Make sure there are no air bubbles trapped between the keypad and the console plastic.
Headphone | Blank Cap |
Jack |
|
|
|
Screw
Headphone
Cable
STEP 7.
Replace the top back cover. Using a #2 Phillips screwdriver, insert (19) screws, retained from ear- lier step, into the plastic cover. Do not tighten screws yet.
Check the cap with the neck and grommet. Make sure the cap is flush with the top back plastic, and adjust if necessary. Tighten screws to secure the back plastics.
This completes the installation of the PVS on the
If you have an
14 |