INSTALLING YOUR PVS ON THE S-TRc AND S-TRx
STEP 1.
Using a #2 Phillips screwdriver, remove the (19) screws that hold the back cover of the display. Next, remove the back cover and the upper cap cover with “Star Trac Logo” on it (You will no longer need this cap cover and, if desired, you can store it away for any possible future use).
Retain all the screws for later use.
Cap
Back
Cover
Screws
STEP 2.
Take the PVS from its package and remove the bubble wrap. Insert the PVS into the rectangle tube on the back of the treadmill. Adjust the new cap into place, (make sure it is below handrail), then fasten with (2) M8 screws and
(2) washers.
Note: Keep all (4) cables on the right side.
STEP 3.
Now, replace the TV keypad on the front dis- play. Carefully remove the label of the center console with a flat screw driver. And then, re- move the (4) screws that hold the center con- sole in place. Retain all the screws for later use.
Cap
Screws and washers
(4)Cables
(4)Screws
CENTER
CONSOLE
LABEL, CENTER
CONSOLE
13 |