LCD
5
|
|
|
|
|
|
|
1 | 2 | 3 | 4 | |||
|
|
|
|
|
|
|
6 | 7 | 8 | 9 |
1.Shows when in Target Mode
2.Shows when in Timer Mode and flashes when you are in another display and timer is running
3.Shows when keypad lock is enabled
4.Shows when alarm is activated
5.Shows when in Timer Mode
6.Shows value of step, distance and calorie, clock / alarm time, timer and user profile
7.Shows when in
8.Colored bar shows the memory weekday and target status
9.Dot matrix shows various icons to indicate the mode / display you are in
EN
GETTING STARTED
SET UP
You must set up the device (as shown below) when you first activate the unit, reset it or change the batteries, or your pedometer will not work properly.
1.To activate the device, pull out the insulation tape underneath the battery cover.
2.Set the clock and user profile (see Clock / User Profile section).
3.Attach the pedometer to your belt or training attire at waist level. Secure it at horizontal position. Improper positioning may result in incorrect data collection.
IMPORTANT FOR ACCURACY
The following conditions may cause incorrect reading of steps taken:
1.Uneven walking pace, such as walking in crowded areas or on uneven floor.
3
PE830_EU_M_EN_R1.p65 | 3 | 2006.8.16, 4:47 PM |