ProForm dtl44941 Console Diagram, STEP-BY-STEP Console Operation, Insert the key into the console

Page 11

CONSOLE DIAGRAM

Displays

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Pulse Sensor

 

Key

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Clip

Note: If there is a thin sheet of plastic on the console, remove the plastic.

CAUTION: Before operating the console, read the following precautions.

Do not stand on the walking belt when turn- ing on the power.

Always wear the clip (see the drawing above) while operating the treadmill.

Adjust the speed in small increments to avoid sudden jumps in speed.

To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and place only a sealed water bottle in the accessory trays.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 10). The reset/off circuit breaker, located on the treadmill frame near the power cord, should be in the reset position (see page 16).

Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothes.

Insert the key into the console. A tone will sound and the three displays will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.

Follow the steps below to operate the console.

1 Insert the key into the console.

When the key is inserted, a tone will sound and the three displays will light.

2 Pressbelt. the Speed + button to start the walking

A moment after the button is pressed, the walking belt will begin to move. Hold the handrails and begin walking.

As you exercise, change the speed of the walking belt as desired by pressing the Speed buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: The console can display speed and distance in either miles or kilometers (see SPEED DISPLAY on page 12). For simplicity, all instructions in this section refer to miles.

11

Image 11
Contents Customer HOT Line QUESTIONS?Model No. DTL44941 Serial No Table of Contents Important Precautions Page Back Before YOU BeginRight Side Make sure that the power cord is unplugged AssemblyLower Tek Screw, without the Round Base Pad, first Pinch the Upright Wire. Firmly tighten the Bolt. AttachUprights. Make sure that the Extension Legs remain Page Page Performant Lubetm Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Pressbelt. the Speed + button to start the walking Console DiagramSTEP-BY-STEP Console Operation Insert the key into the consoleWhenkey. you are finished exercising, remove Change the incline of the treadmill as desiredMeasure your 5 heart rate if de- sired HOW to USE the Hand Weights HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Top TroubleshootingProblem The power turns off during use Problem The walking belt slows when walked on Exercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key Qty Description Part LIST-Model No. DTL44941DTL44941 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT HOW to Order Replacement PartsLimited Warranty