JVC FS-G2 manual Warnings, Cautions and Others, Important For Laser Products, For U.S.A

Page 30
Warnings, Cautions and Others

Warnings, Cautions and Others

Mises en garde, précautions et indications diverses

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK.

 

DO NOT REMOVE COVER (OR BACK)

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION—ATTENTION—Touche STANDBY/ON STANDBY/ON button!

Disconnect the mains plug to shut the power off completely (all

lamps and indications go off). The IMPORTANT FOR LASER PRODUCTS STANDBY/ON button in any position does not disconnect the mains line.

•When the unit is on standby, the STANDBY lamp lights red.

•When the unit is turned on, the STANDBY lamp goes off.

The power can be remote controlled.

ATTENTION—Touche IMPORTANT POUR PRODUITS LASER STANDBY/ON

Déconnectez la fiche secteur pour mettre l’appareil complètement hors tension (tous les témoins et toutes les

indications s’éteignent). La touche Manual background STANDBY/ON dans n’importe quelle position ne déconnecte pas l’appareil du secteur.

•Quand l’appareil est en mode de veille, le témoin STANDBY est allumé en rouge.

•Quand l’appareil est sous tension, le témoin STANDBY s’ éteint.

L’alimentation ne peut pas être commandée à distance.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

IMPORTANT FOR LASER PRODUCTS

1.CLASS 1 LASER PRODUCT

2.CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.

3.CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

4.REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT.

IMPORTANT POUR PRODUITS LASER

1.PRODUIT LASER CLASSE 1

2.ATTENTION: N’ouvrez pas le couvercle supérieur. Il n’y a aucune pièce réparable par l’utilisateur à l’intérieur de l’appareil; confiez toute réparation à un personnel qualifié.

3.ATTENTION: Risque de radiations laser visible et invisible quand l’appareil est ouvert et que le système de verrouillage ne fonctionne pas ou a été mis hors service. Évitez toute exposition directe au rayon.

4.REPRODUCTION DE L’ÉTIQUETTE: ÉTIQUETTE DE PRÉCAUTION PLACÉE À L’INTERIEUR DE L’APPAREIL.

G-1

Page 29 Page 31
Image 30
Page 29 Page 31
Contents FS-G2 -Consistsof CA-FSG2and SP-FSG2 COMPACT COMPONENT SYSTEMINSTRUCTIONS LVT1345-001BCAUTION-STANDBY/ON button Warnings, Cautions and OthersFor U.S.A DANGERContents Listening to FM and AM BroadcastsPower sources PrecautionsInstallation Introductionp q w e Location of the Buttons and ControlsMain Unit Top viewPRGM SOUND REC Location of the Buttons and Controls continuedSLEEP 12 3 MP3 ALL RANDOM MONO STRemote Control Unpacking Putting the Batteries into the Remote ControlGetting Started Connections1Connect the supplied AM loop antenna to the Connecting Other EquipmentNOW you are ready to plug in the unit AM LOOP terminalOn the remote control ONLY Setting the ClockTurning On the Power On the remote control ONLY 1 Press CLOCK/TIMER1 Press BASS/TREBLE once to adjust TREBLE Adjusting the VolumeAdjusting the Tone Bass/Treble TREBLE twice to adjust the treble1 Tune in to the station you want to preset Tuning in to a StationPresetting Stations 3 Press ¢ or 4 to select a preset numberTuning in to a Preset Station On the remote control ONLYOn the remote control ONLY Playing Back the Entire Disc-NormalPlay When playing CD-Rsor CD-RWsPlaying Back Discs 1 Press 0 OPEN on the unitBasic Disc Operations On the remote control ONLY 1 Place a discTo check the program contents Programming the Track Playing Order -ProgramPlayRepeating Tracks-RepeatPlay Playing Back Discs continuedPlaying at Random-RandomPlay Displaying the Remaining Time during PlaybackOn the unit ONLY Playing Back TapesPlaying Back a Tape 1 Press &/ stop/cassette holder openListening to the External Equipment Using an External EquipmentSet the volume level to the minimum position Press AUX2 Close the cassette holder gently RecordingRecording on a Tape 4 Press ‡ recordingplayer as the source Recording Discs -DiscSynchronized RecordingPress CD 3/8 to select the CD Press 7 to stop the disc playback2 Press CLOCK/TIMER repeatedly to Using the TimersUsing the Daily Timer 6 Press VOLUME +/- to adjust the volumeHow the Sleep Timer actually works Using the Timers continuedUsing the Sleep Timer To deactivate the timer temporarilyTo clean the disc MaintenanceCleaning the unit General NotesPossible Cause TroubleshootingSymptom ActionOutput Power SpecificationsSupplied accessories Amplifier Section-CA-FSG2Page Page FS-G2COMPACT COMPONENT SYSTEM EN 2004 Victor Company of Japan, Limited1204AIMMDWBET LVT1345-002B SYSTEME DE COMPOSANTS COMPACTEnglish Français FS-G2IMPORTANT POUR PRODUITS LASER Warnings, Cautions and OthersIMPORTANT FOR LASER PRODUCTS For U.S.ACAUTION: Proper Ventilation For Canada/pour le CanadaFor Canada/pour le Canada Attention Aération correcteInstallation EnglishPrecautions Power sourcesContents EnglishListening to FM and AM Broadcasts Location of the Buttons and Controls VOLUMETIMER Main Unit12 3 MP3 ALL RANDOM MONO ST SLEEPPRGM SOUND REC EnglishRemote Control Location of the Buttons and Controls continuedEnglish Unpacking Getting StartedPutting the Batteries into the Remote Control ConnectionsNOW you are ready to plug in the unit Getting Started continuedConnecting Other Equipment EnglishOn the remote control ONLY Setting the ClockTurning On the Power On the remote control ONLY 1 Press CLOCK/TIMERAdjusting the Tone Bass/Treble Basic and Common Operations continuedAdjusting the Volume On the remote control ONLYOn the remote control ONLY Tuning in to a StationPresetting Stations 1 Tune in to the station you want to presetselect a preset number 2 Press PRESET UP orPRESET DOWN repeatedly to Listening to FM and AM Broadcasts continuedPlaying Back the Entire Disc-NormalPlay When playing CD-Rsor CD-RWsPlaying Back Discs EnglishTo check the program contents On the remote control ONLYOn the remote control ONLY 1 Place a disc Playing Back Discs continuedOn the remote control ONLY Press REPEAT repeatedly before or during playbackOn the remote control ONLY On the remote control ONLYPlaying Back a Tape Press &/ stop/cassette holder openPlaying Back Tapes EnglishUsing an External Equipment 1 Set the volume level to the minimum position2 Press AUX Listening to the External EquipmentEnglish RecordingRecording on a Tape On the unit ONLY2 Close the cassette holder gently Recording Discs -DiscSynchronized RecordingOn the unit ONLY Press CD 3/8 to select the CDOn the remote control ONLY Using the TimersUsing the Daily Timer 2 Press CLOCK/TIMER repeatedly toHow the Sleep Timer actually works Using the Sleep TimerOn the remote control ONLY To deactivate the timer temporarilyTo clean the disc MaintenanceCleaning the unit EnglishEnglish TroubleshootingSymptom Possible CauseEnglish SpecificationsSupplied accessories Amplifier Section-CA-FSG2MEMO FS-G2COMPACT COMPONENT SYSTEM EN, FR 2004 Victor Company of Japan, Limited1204AIMMDWBET
Top Page Image Contents