STEP #3 – ASSEMBLE CAM ASSEMBLY AND LEVERAGE CURL ARMS :
1.Slide one of the CAM ASSEMBLYS onto the mount of the Main Frame as shown, the side of CAM ASSEMBLY that has shaft slide onto the mount first.
2.After the CAM ASSEMBLY has been slid onto the mount, slide one of the LEVERAGE CURL ARMS onto the corresponding shaft of the CAM ASSEMBLY as shown below, At the same time, align the hole of the shaft with the hole of the mount of the LEVERAGE CURL ARMS, using one (M8x50mm SHOULDER BOLT), one (M6 FLAT WASHER), and one (M6 NYLOCK NUT), then install one END CAP and one (M8x20mm SOCKET HEAD BOLT). Do not tighten these bolts at this time.
3.Repeat step 1 thru 2 with the remaining CAM ASSEMBLY and LEVERAGE CURL ARM as shown below.
STEP #3 Completed
Page 14