Star Trac 620 -8173 manual Box…

IN THE BOX…

1)LCD Personal Viewing Screen

2)Manual

G

CONNECTION IDENTIFICATION

G G G G1
		2	3	4	5	6	7	8
1	DC Power In. 2.5mm DC jack		6	AUX Audio/Video Input. RCA jacks
2	AUX TV Controller Cable port. RJ45 jack		7	AUX Audio Output. 2.5mm stereo jack
3	Firmware Download USB jack		8	RF Signal Input. TYPE “F Connector
4	AUX RGB In. HD-15 jack
5	AUX Audio Input. 2.5mm stereo jack

Mounting the Screen and Making the Connections

Use the four screws (included) to fasten the screen to the mount. Using screws other than those supplied, may result in damage to the screen. It is highly recommended to not use a power tool when tightening these screws, as this may result in damage to the screen. Use a #2 Phillips screwdriver, taking care not to over-tighten! (SEE PAGE 24)

SCREEN MOUNTING SCREWS

Fasten the F-connector of the coaxial cable on to the fitting on the rear of the screen. It is important that care be taken with this connector, as over-tightening will result in serious damage to the screen. This connector should be started using only fingers and then tightened to 20 inch-pounds of torque, slightly more than finger-tight.

For Strain Relief slide the DC power plug through the pre-installed wire tie and insert it into the DC jack on the TV. Pull the nylon tie snug around DC cable. This will also prevent the cable from becoming accidentally unplugged during use.

When the Star Trac TV secondary TV controller is installed, insert the controller cable’s RJ45 plug into the jack on the back of the TV. Confirm that the plug’s spring clip snaps into place and the plug is seated properly and securely in place.

October, 2012 (Version 7) STAR TRAC PERSONAL VIEWING SCREEN OWNER’S GUIDE

5