Assembly

Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

In addition to the included allen wrench, assembly requires a phillips screwdriver			, two adjustable
wrenches	, a rubber mallet	, and a pair of pliers	.

Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part refers to the key number of the part, from the PART LIST on page 14. The number after the dash indicates the quantity needed for assembly. Note: Some parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached.

M8 Nylon	M10 Nylon	M10 Split	M8.5	M10.5
Locknut (38)–6	Locknut (33)–6	Washer (59)–2	Washer (35)–2	Washer (55)–2
M4 x 12mm	M4 x 19mm Flange	M8 x 25mm Button	M8 x 45mm Button Bolt (50)–4
Screw (42)–4	Screw (36)–6	Screw (56)–2	M8 x 45mm Button Bolt (50)–4
Screw (42)–4	Screw (36)–6	Screw (56)–2
	M10 x 74mm Button Bolt (67)–2		M10 x 75mm Carriage Bolt (34)–4
		Pedal Arm Bolt Set (40)–2

1.Identify the Front Stabilizer (10). While another per- son lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33). Make sure that the Front Stabilizer is turned so the Wheels (22) are not touching the floor.