ASSEMBLY
Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires that you have a phillips screwdriver | , two adjustable wrenches | , a | |
rubber mallet | , and a pair pliers | . |
|
1.While another person holds the Console (6) near the Upright (3), insert the Resistance Cable (26) down through the Upright.
2.While another person holds the Upright (3) near the Frame (1) as shown, connect the Extension Wire (61) to the Sensor Wire (25).
Next, connect the Resistance Cable (26) to the Lower Cable (59) in the following way:
•Refer to drawing A. Pull up on the metal bracket, and insert the tip of the Resistance Cable (26) into the wire clip on the Lower Cable (59) as shown.
•Refer to drawing B. Firmly pull the Resistance Cable (26) and slide it into the metal bracket on the Lower Cable (59) as shown.
•Refer to drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together.
Slide the Upright (3) onto the welded bolts on the Frame (1). Make sure that the Lower Cable (59) doesn’t become caught on the Upright or the Frame. Be careful to avoid pinching the Lower Cable, the Resistance Cable (26), the Sensor Wire (25), or the Extension Wire (61) between the Upright and the Frame. Tighten an M10 Nylon Locknut (29) onto each welded bolt.
1 | 6 |
|
|
| |
| 26 |
|
|
| 3 |
2 |
| 29 |
| 3 |
|
| 26 | 61 |
| 59 |
|
| 1 |
|
|
| 25 |
| Welded |
|
| Bolts |
|
A | B | C |
Metal |
| 26 |
Bracket |
| |
|
| |
26 | 26 |
|
|
| |
59 | 59 | 59 |
6