MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the elliptical crosstrainer regularly. Replace any worn parts immedi- ately.
To clean the elliptical crosstrainer, use a damp cloth and a small amount of mild dish soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. Refer to assembly step 5 on page 6 for replacement instructions. The console requires four “D” batteries.
HOW TO LEVEL THE ELLIPTICAL CROSSTRAINER
After the elliptical crosstrainer has been moved to
the location where it will be used, make sure that the ends of
both stabilisers are touching the floor. If the ellipti-
cal crosstrainer
rocks slightly during use, turn one or both of the level- ing feet under the front stabiliser until the rocking motion is eliminated.
HANDGRIP PULSE SENSOR TROUBLE-SHOOTING
•Avoid moving your hands whilst using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings.
•Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.
•For the most accurate heart rate reading, hold the metal contacts for about 15 seconds.
•For optimal performance of the handgrip pulse sen- sor, keep the metal contacts clean. The contacts can be cleaned with a soft
HOW TO MOVE THE ELLIPTICAL CROSSTRAINER
Stand in front of |
|
the elliptical |
|
crosstrainer, hold |
|
the handlebars |
|
firmly, and tip the |
|
elliptical cross- | Wheel |
trainer until it |
|
can be moved |
|
on the front |
|
wheels. Carefully |
|
move the ellipti- |
|
cal crosstrainer to the desired location and then lower it. Due to the size and weight of the elliptical crosstrainer, use extreme caution whilst moving it.
12